The New Hanger Kit is only 5/8" wide but is 15" long and has 6 holes and a "j" hook at the bottom of it to hook on the new extensions. This will enable you to hang heavy pieces on the lower sections of your panels.

You can get an entire kit, one anchor hanger, 2 extensions, and 5 "s" hooks.

If you only hang large heavy pieces towards the top of your panel you can get the anchor hanger alone. Then if you later decide you want extensions they can be purchased separately as well.

There are two types of bars that you can add to the top of your panels to give them extra strength. Each type comes in long and short to give you variety with your booth setup:

Support Bar: A telescoping bar used at the top of your panels for stabilization. They are best used in a corner to make the hypotenuse of a right angle triangle. They have a tube on the end that slips around the short leg at the top of the panel. It leaves that leg open so you can still use swing arm lights.

• Extra Short Support Bar: expands from 2' to 4'
• Short Support Bar: expands from 4' to 7'
• Long Support Bar: expands from 6 1/2' to 12'

Banner Bar: A telescoping bar used at the top of your panels. These bars are used primarily with track lighting, to prevent tall customers from hitting their heads, or for extra clearance. They differ from the support bars in that they rise 8" before they span across the booth giving you extra height. They use only one coupler to connect to the top of the panel leaving the top open for swing arm lights, if needed.

• Extra Short Banner Bar: expands from 2' to 4'
• Short Banner Bar: expands from 4' to 7'
• Long Banner Bar: expands from 7' to 12'

There are three types of stiffeners that can be used to reinforce your panels:

Standard Stiffener: This piece of U channel metal has an opening in the middle for legs to pass into that helps keep 2 panels in a straight line. They are about 9" long and powder coated silver vein.

T-Stiffener: The T stiffener can be very useful for you. When you have a panel you want to come out from the joint of two panels (that are in a straight line), you can put a T stiffener to secure that panel that is coming out. We recommend using the T stiffener when you have this situation in your booth.

L-Stiffener: This, with the straps will help secure your corners. This product does not actually support your corners completely. If you are already using the Support Bars to support your corners then chances are that you will not need the L stiffener. The L stiffener will add support but it does not hold the panels at the exact angle, like you assume it would. The support bars are you best bet in securing angles. But it would be helpful in a situation where you just cannot use your support bars, or have just two panels together and don't want to use a support bar. The L stiffener would help in those cases.

Extend the vertical space on your Pro Panels!

Add 20" of vertical space at the top of your panels using this extender. It will easily fit on any of our standard Pro Panels or our 6' and 7' KD Pro Panels.

If you need extenders for the 8' KD Pro Panels we can make those too for the same low price. We must know in advance that you have 8' KD's so we can make the small adjustments to the Extenders.

Just order each extender by color and width to fit your panels. We do make Extenders in all the sizes we make panels, even the custom ones.